Rok Power Washer Instructions -

Slide the main handle frame into the receiver slots on the base. Secure it using the provided bolts or quick-release knobs. Snap the spray gun holster and nozzle holder into place.

Screw the high-pressure hose onto the main unit's outlet (usually on the front or bottom).

Fill the integrated detergent tank (or place the siphon tube into a bottle) with a specialist pressure washer detergent. , as they can ruin the internal pump seals. Snap the Black Soap Nozzle onto the end of the spray wand. rok power washer instructions

:

Over time, dirt can clog the nozzle tips, causing the pump to pulsate. Use a straightened paperclip or a nozzle cleaning tool to clear out any debris from the tip hole. Slide the main handle frame into the receiver

| Issue | Possible Cause | Solution | | :--- | :--- | :--- | | | - Air in the system - Clogged inlet filter - Kinked water supply hose - Incorrect nozzle installed | - Squeeze trigger to purge air - Clean or replace inlet filter - Straighten or replace hose - Ensure nozzle is clean and correct | | Pulsing/Intermittent Pressure | - Inadequate water supply - Water supply hose too long (over 100ft) - Blocked nozzle | - Ensure faucet is fully open - Shorten the supply hose - Clean or replace the nozzle | | Motor Won't Start (Electric) | - Outlet not powered - GFCI tripped - Extension cord too long | - Try a different outlet - Reset the GFCI on the plug or outlet - Use a shorter or heavier gauge cord | | Engine Won't Start (Petrol) | - Out of fuel - Stale fuel - Dirty air filter - Spark plug issue | - Refill fuel tank - Drain and replace old fuel - Clean or replace air filter - Check spark plug wire and plug | | Detergent Not Dispensing | - Wrong nozzle attached - Regulating sleeve not engaged - Clogged filter or siphon tube - Low pressure from pump | - Install the black detergent nozzle - Pull back the regulating sleeve on the lance - Clean the filter on the end of the siphon tube - Check for any of the issues above |

This comprehensive manual provides step-by-step instructions to get your ROK pressure washer running efficiently while protecting your investment. 1. Pre-Operation Checklist and Safety Screw the high-pressure hose onto the main unit's

Turn the faucet on fully to ensure adequate water pressure.

Verify oil and fuel levels. Use fresh unleaded fuel; if the gas has been sitting for over 30 days, replace it or add a stabilizer.

Let the soap sit for 3 to 5 minutes to break down the grime, but do not allow it to dry completely on the surface.