DP Fit for Life Dual Trac 20 is a classic home gym system. While official digital manuals from the manufacturer (Diversified Products) are rare due to the age of the equipment, the assembly follows a standardized sequence common to most vertical multi-station weight stack machines. Preparation & Required Tools
Align the brackets on the center beam with the holes in the stabilizers. Insert the long hex bolts from the bottom facing up. Slide on a washer, thread the aircraft nut, and tighten them finger-tight for now.
: Features a variable resistance system with a triple/double pulley mechanism. Core Assembly Steps
Slide the onto the pivot axle at the top of the main frame.
: Slide the weights onto the rods. Ensure the pin holes face forward and any orientation marks face outward for easy access. dp dual trac 20 assembly instructions full
You will need two adjustable wrenches (or a socket wrench set with 1/2-inch, 9/16-inch, and 3/4-inch sockets), a set of Allen wrenches, a rubber mallet, and a tape measure.
Bolt the top crossmember to the uprights.
Mount the main post using carriage bolts and stabilizing plates, securing them with lock nuts. Due to the angle of the design, an extended flex bit is often helpful.
: Ensure the unit is level once fully assembled to reduce wear on bearings and bushings. DP Fit for Life Dual Trac 20 is a classic home gym system
Keep a can of silicone spray or 3-in-1 oil handy. Lubricating the guide rods during assembly is much easier than doing it afterward. Step 1: Base Frame Construction
Is your machine missing any that you need to replace?
The most commonly needed replacement parts include:
Choose a flat, level surface at least 8 feet by 8 feet. Insert the long hex bolts from the bottom facing up
Assembling your DP Dual Trac 20 requires attention to detail and a bit of patience. By following these step-by-step instructions, you'll be able to successfully assemble your treadmill and start achieving your fitness goals. Remember to always follow the manufacturer's guidelines and take necessary safety precautions to ensure a smooth and enjoyable assembly process.
Attach the leg developer bracket to the very front tip of the seat support frame. Step 3: Top Crossmember
Attach the front and rear stabilizers to the main base frame. Use the long carriage bolts provided, ensuring the curved ends of the stabilizers face outward for maximum stability.